This is a little program that converts G-Code generated by SolidCam into G-Code that is correctly formatted to be used with the Sinumerik 810D controller on a Hardinge VMC1000 CNC machining center.
Please click the link below to download (approximately 3.5Mb).

Click HERE to download.

Should you have any questions about G-CodeWorks please contact:

Prof. Olaf Diegel
Faculty of Design & Creative Technologies
300 Queen St
Level 11, Symphony House
Private Bag 92006
Auckland 1142, NZ

Tel: +64 9 921 9485
Fax: +64 9 921 0421
Email: olaf.diegel@aut.ac.nz